Whirlpool gas stove igniter keeps clicking. Whirlpool gas stove igniter keeps clicking; when you arrive home eager for a delicious dinner, you are immediately thrown off your schedule by having to wait for your gas stove to ignite.
Simply moving the switch that turns it on doesn’t work. You may think to yourself, “Why do I have to go through this headache yet again?
This is so irritating!” But when doing so, you forget about how unsafe this act can be when dealing with a stove burner and boiling water.
Whirlpool gas stove igniter keeps clicking
Clicking is actually quite natural when it comes to lighting a stove. If you have a gas stove with a spark ignition system, this can be especially true.
A sparking unit will normally click up to 3 times before it lights your stove, but sometimes that clicking may continue even after your flame is initially lit.
Following are some of the more common causes and solutions you should try first:
Ignition issues
When attempting to light your gas stove, you could find that the flames of your pilot light may die out (especially if you try to bake something below 375°F). The pilot flame may fail to ignite the burners in two ways.
If it was poorly adjusted, to begin If the tubes running from the pilot are clogged up or blocked.
On the other hand, an electric igniter can help ensure your oven lights right away and won’t be susceptible to problems in the second category (at least not so long as it’s receiving voltage).
However, there could be a number of reasons why your oven might have failed to light, including:
(1) An improperly adjusted gas valve. (2) Clogged gas tubes. ( 3) A power failure caused by a problem with the igniter. ( 4) No gas getting into the valves through clogged pipes or a broken pipe/tank.
Spark Ignition Switch and Harness problems
There’s a small chance that one of your stovetop burners’ spark ignition switches could be defective. It acts as a go-between sending a flow of power to the ignition module once the electric current is activated.
If its current contacts become wet, or something is preventing them from closing, the whole thing will continue operating in the default position no matter the adjustments made on your dial.
Each switch can be tested individually to see if it still functions on its own and when faulty, it should be replaced by another.
Replacing Spark Module
The spark module is important to the ignition system of your stovetop burners. It’s what provides power to each of the electrode surfaces in the burners, which will cause a spark when it comes in contact with fuel.
Replacing your spark module if it is no longer working could cure problems with sparking continuously. Before you replace your spark module, first test your spark ignitor switch as it can also be at fault.
If everything checks out okay, replace your spark module so that you’re not experiencing any more issues.
Defective Control Panel
The control panel acts as the brain of the oven. It controls everything that happens on the gas range.
Faulty controls may be the cause of a faulty oven. An ignition system failure is usually the result of faulty power output from the controller.
You should always consult a professional appliance repair specialist when troubleshooting control board problems, who can advise you as to which controls are defective and where they need to be replaced.
Related Guides