Whirlpool dishwasher start button not working

Whirlpool dishwasher start button not working. When your dishwasher won’t operate, the first thing you should check is if the display lights are on.

Perhaps they work in some and don’t in others because some of them are employed.

Dishwashers have touchpads that enable you to switch cycles and options while they run. If the touchpad is not working correctly or at all, follow these instructions to fix it:

Whirlpool dishwasher start button not working

whirlpool dishwasher start button not working

Make sure your dishwasher is plugged in and switched on. Be sure to wait for the door latch assembly to complete its cycle before re-testing the cycle operation.

Ensure the dishwasher door is secure to make sure that it doesn’t get stuck or jammed during wash cycles.

If cleaning instructions will not alleviate the problem, follow these steps:

Defective Touchpad

Ensure that the dishwasher has power and test the display by pressing buttons on-screen. If you’re unable to get the display to power on, check that the button panel is working correctly by pressing the buttons.

Usually, a malfunctioning button remote means that both need replacing. If you can’t purchase the remote separately from the panel, both of them will need to be replaced.

Both the touchpad and control panel should be replaced

First, ensure that all of the buttons on the display are functioning correctly. If you notice that some of them aren’t responding as they should be responding, it’s possible that you need to replace your control panel.

Most dishwashers come with a touchpad and control panel in one unit or are sold together. If your dishwasher isn’t buyable separately, you’ll need to replace both together in order for it to work correctly.

It’s also possible that the touchpad is fused to the main body of the dishwasher, so if this is the case then you will want to replace them both together.

Faulty Main Control Board

If your dishwasher is no longer responding to the touchpad, there are a few causal parts that need to be tested before you replace the main control board.

Check to see if the touchpad is receiving voltage from the main control board and if it isn’t, then check all of the wiring connecting up to the touchpad; ensure nothing is cracked or burnt out.

If some of these things check out, then you’ll want to check with a voltmeter (if possible) to make sure that each button has continuity with the ground when pressed and that none of them have an electrostatic buildup preventing them from making contact.

Ensure the door latch works properly

Make sure to plug your dishwasher in and that the circuit breakers haven’t been tripped. Wait for the drain cycle to finish and then flip the switch on to start it up again.

Make sure that your latch is working properly if things don’t go as planned, you’ll want to know so you can fall back on a proper backup plan.

The power switch must be turned on

The dishwasher must be turned on. Some switches are positioned inside a compartment located below or near your sink.

If resetting does not work, you must disconnect power to restart the board. After one minute, restore power and check if the dishwasher will reboot.

Is there a reset button on a Whirlpool dishwasher?

The drawback for some Whirlpool appliances is that they don’t have reset buttons, but most of their models do contain fault codes. You can identify them by checking the user guide.

If you find no fault code info in there, we suggest that you check out their website and see if the reference manual has an answer to your query. This isn’t very commonly needed, so they should be able to help.

How do I reset my Whirlpool dishwasher?

If your Whirlpool dishwasher has an issue that isn’t being fixed, you might need to unplug the machine at its power source or turn the circuit breaker off in order to reset the dishwasher.

Wait a few minutes and turn it back on before attempting to load any dishes.

Related Guides

 

Leave a Comment