Tanaka Leaf Blower Won’t Start. Leaves on your lawn might look unappealing in comparison to a leaf-free yard. However, there are many steps you can take to remedy this problem.
You can dry and remove leaves by sweeping the ground with a broom or using a blower capable of blowing away the leaves conveniently.
A leaf blower is an electric device and there might be times when it stops working properly.
Most common ailments associated with these accessories include operational inefficiencies or mechanical failures like problems getting started.
To understand what’s wrong and solve the issue, check out some of these most frequent discomforts that impact blowers and their probable solutions:
Tanaka Leaf Blower Won’t Start
The leaf blower won’t start if the carburetor is clogged or faulty. Clean the carburetor with carburetor cleaner and try to start it again. If the leaf blower still doesn’t start, rebuild or replace the entire carburetor.
The leaf blower needs a fully-functioning starter assembly that engages the crankshaft of the engine in order to turn over and start on its own.
The following is a discussion of some problems with the Tanaka leafblower when it won’t start.
Issue With Ignition Coil
The ignition coil is part of a system in a vehicle that sparks the fuel in the internal combustion engine.
When an ignition coil fails, this can cause problems with starting and even prevent your leaf blower from starting at times.
If there are no warning signs that indicate that the coil has failed, it is best to test it to know for sure because issues with the spark plugs or wires leading to them can cause failure as well.
If the ignition coil is found faulty, replace it as soon as possible for proper leaf blower performance and safety of those using it.
Problem With Spark Arrestor
The spark arrestor is a small screen that prevents the engine from emitting sparks. Over time, the spark arrestor can become clogged with soot.
When this happens, you must clean the screen to clear obstructions. To unclog the spark arrester, remove it and clean it with a wire brush to get rid of any obstructions like soot or dirt. You may also replace the spark arrestor.
Error In Fuel Filter
For a leaf blower that won’t start, it’s more likely than not that the issue is due to a clogged fuel filter.
A combustible and potentially flammable substance like gas doesn’t sit well in containers of any kind and will absorb water, causing it to separate into two layers.
A thin layer of liquid at the bottom and a thicker, gunk-like substance on top. When this happens, the fuel filter can quickly become clogged.
If you’re using old or improperly stored gasoline or another type of flammable substance in your leaf blower, drain some old fuel out of the tank and replace the fuel filter with a new one as soon as possible.
Cause Of Rewind Spring
The rewind spring is a special device that helps you start the chainsaw. When you pull the starter rope, it will recoil onto the pulley of the chainsaw’s engine.
If this part is broken and not working, then it won’t be able to recoil properly onto the assembly which means the chainsaw won’t startup.
It may just need to be replaced by a new rewind spring or an entirely new starting assembly consisting of these parts.
Recoil Starter Malfunction
The recoil starter assembly engages with the crankshaft to turn over the engine.
If the recoil starter assembly is defective, this will prevent the handheld leaf blower from starting.
Remove the starter assembly and inspect it to determine if it’s working properly.
When you pull on the starter rope, tabs extending out of either side should grab onto a hub in order to engage with the engine, causing it to turn.
After you let go of the rope, these tabs should retract back inside so that when you release more rope from the pulley-topped block it winds back into itself by wrapping around this top pulley again. If your starter assembly isn’t working correctly, then replace it.
Defective Carburetor
The carburetor may be clogged. A clogged carburetor is caused by using the leaf blower for a long period of time.
Eventually, some of the ingredients in the fuel will evaporate, leaving behind a thicker, stickier substance that can block the flow from the propellant to chambers in the engine.
This sticky substance can cause inconsistent operation of your equipment and you might even have to replace or rebuild parts.
Faulty Spark Plug
Inspect the spark plug. If the porcelain insulator is cracked, there are signs of wear at the electrode tip or it is damaged, or there is heavy carbon buildup in the electrode’s round face, replace the spark plug.
To determine if the spark plug is defective, use a spark plug tester and see if you can see a strong spark between its terminals when attempting to start an engine.
If there is no quartz discharge at all from its terminals, this indicates that the spark plug is defective and should be replaced.
Pulley For Recoil Starters
If your pull-start rope is broken or malfunctioning, you will be unable to start up the leaf blower.
Look inside your user manual for details on where this part is located exactly in your device and examine it for damaged pieces.
You must then purchase and substitute a new one or have it repaired by a professional if it’s too costly or difficult to replace all on your own.
Tanaka Leaf Blower Won’t Start
Related Guides