LG washer stops mid cycle. LG washing machines are designed to automatically detect and adjust the amount of water needed during the wash cycle.
In some cases, however, the washing machine may stop mid-cycle due to a clogged drain hose or faulty door switch.
Cleaning any debris that has clogged up internal hoses can help restore normal operation. We’ll discuss common reasons for LG washers to stop mid-cycle and how to fix them here.
LG washer stops mid cycle
LG washer stops mid-cycle: you should check whether the door on your washing machine is secure.
Customers report that their machines stop mid-cycle if the door is not properly closed.
If watering the yard or starting a second load of laundry, be sure to close both doors securely before the washer begins.
Also, inspect for damage around the latch mechanism and make sure that any holes or splits within this area are patched up with waterproof sealing material.
The door lock motor and switch assembly are faulty
The washer’s door is secured shut by the door lock when it is in use. The washer can then begin operating after closing the door.
The door switch prevents the washer from operating when the washer door is not latched shut.
A defective door lock will cause the product to stop mid-cycle. Either the mechanical or electrical component of the door lock may fail. Look for damage to the door lock.
If the door lock is damaged or does not latch properly, this should be replaced immediately so that you don’t risk some as yet unforeseen danger to yourself and your family.
Consult your in-depth diagram and test each of these switches with a multimeter to determine if they have failed electrically.
If one of these switches doesn’t have continuity, replace it immediately so that you don’t risk some as yet unseen tragedy occurring randomly to you or someone else in your household at a later date when you think all wards are secure.
Defective Water Inlet Valve
During the rinse cycle, water is poured out of the wash tub and back into the washer because it acts as a centrifuge and creates the spin cycle.
If the water inlet valve loses its seal, water will enter but never drain back out of the washtub, which causes it to overflow onto your floor.
A faulty water inlet valve can also cause leaks during this process because if too much pressure isn’t released, or if it doesn’t drain whatsoever there’s bound to be problems.
Test continuity with a multimeter to determine if your water inlet valve is defective. Replacing your old with a new reliable one.
Lid switch assembly problem
It should, by default, prevent the washing machine from spinning when the lid is open and prevent rotation when the lid is closed.
If this switch breaks, the machine may begin to start spinning despite the lid being open.
As such, we must test out each of these switches for continuity in order to detect whether or not any may have failed or are not functioning properly to see if they can be replaced with a new set if one is needed.
Replace the Timer
There might be a problem with the timer. Before you replace your appliance’s timer entirely, test the wires for continuity and make sure that it isn’t any of your appliance’s wire harnesses that are causing a problem.
Also, check for plumbing blockages underneath your machine to understand why there is no water flowing into the washer at all.
An issue with Main Control Board
It is possible that the main control board is malfunctioning. The main control board is rarely to blame for this symptom.
Check the circuit boards and heat sink first before replacing the main control board.
Thermostat failure
In the event of a power outage, while you are doing laundry, your washing machine will also shut off, since it runs on electricity.
During a cycle, a malfunctioning thermostat, an overfilled rinse cycle, or even a problem with the pump can cause a washer not to drain properly.
LG washer stops mid cycle
Related Guides