Kenmore Washer Leaking Water

Kenmore Washer Leaking Water. When your washing machine leaks, there are a number of likely causes.

By examining the symptoms listed below it is possible to determine what might be happening underneath the washer itself.

When it fills up with water when it’s not in use one possible cause of this problem is too much detergent residue inside the detergent tray immediately after washing a load of clothes and too many clothing items for the conditioner’s capacity as well as rinsing failed or didn’t take place are common reasons for such problems.

Kenmore Washer Leaking Water

kenmore washer leaking water

Listed below are some common Kenmore washer problems when the washer starts leaking water.

Issue With Drain Hose

The drain hose may be leaking. If you see any holes in the drain hose, then you need to inspect it. You will need a new one if there are any holes.

What may have caused it to tear is if the washer is pushed too far up against the wall, its own weight can rub against the wall and cause some small perforations in which water will escape from creating a leak that might otherwise go unnoticed.

Problem With Tub Seal

If the tub seal on your washing machine is torn, it can cause water leakage. Water leaking from a torn tub seal can go through the metal bearings and cause damage to those as well.

A broken metal bearing will be just as costly to replace as a new tub seal. Replace both components at the same time to prevent complications down the road.

This repair is a tough one because you’ll have to remove pretty much everything else in order to get access to these parts, but don’t worry we hope that level of precision pays off.

Error In Drain Pump

The drain pump is responsible for draining the water from your pool. It is possible that the drain pump cannot drain your pool properly if it is cracked, broken, or damaged.

This will result in water leaking back into the pool. If the drain pump is leaking water back into your pool, you may need to replace it.

Water Pump Failure

A leak under the washer often indicates a problem with the water pump or one of the hoses attached to it.

If you notice shaking or unstable movement during a wash cycle, it may be because the water pump is damaged.

The rubber gasket of the water pump may also be dirty which could result in this leaking problem. When you use hot water, a leak will usually appear under the washer.

Check if these connections appear loose or clogged as well as visually inspect whether there is any damage on these parts.

Filter or Catch Basket Clogged

The catch basket of a washing machine is somewhat similar to one in a dryer. Over time it usually becomes overtaken by grime and fibers which become visible in your laundry.

This may also cause the washer to leak from the bottom.

One can find their rinse clothes filter either along the top corner of the washing machine’s drum or adjacent to its center column drum, or at its end where you might find a removable screen that can be cleaned.

Newer washing machines aren’t normally equipped with these baskets.

Pump-To-Tub Hose

To test the tub-to-pump hose, submerge both ends of the hose into a pitcher of water. The water should be running freely through the hose.

The second part of this test is to submerge one end of the hose in a sink partially filled with water and then submerge the other end in a sink filled entirely with water.

If the water does not flow freely from one end to another, there is a problem with either the valves or drain line for that section of plumbing.

Broken Or Cracked Couplers

The coupler is a rubber seal between the washing machine’s drum and motor. It’s designed to break in case of motor failure so that the main equipment does not become damaged.

It’s a lot cheaper to replace than the part of your washing machine which has broken down causing it to malfunction, so that would be the best choice once you have confirmed your washing machine has a broken coupler.

If your clothes are soaked during or even after rinsing and you notice a leakage coming from the bottom of your washer, then that is strong evidence this piece is either broken or missing altogether.

Related Guides