Husqvarna chainsaw chain not moving. An issue with your Husqvarna chainsaw chain where it is not moving may be due to the chain being tensioned too tight.
This can cause the chain to not spin when you engage the throttle, potentially damaging vital parts of your chainsaw.
Another possibility could be that if you are operating your saw outside in a very warm environment, the heat may cause a change in the tension required by your chain and thus causing an unsteady blade path or other movement issues.
To solve this, you can count on our technicians who have been trained to help identify these kinds of problems and come up with a solution quickly.
Husqvarna chainsaw chain not moving
Husqvarna chain saw chains have stalled. This article will address common reasons why this problem has occurred and offer remedies for each case.
Defective Clutch
The clutch pads impact the clutch drum so that the chain can rotate. If the clutch pads are worn out.
The motor won’t run because it can’t engage the idler with the drive sprocket when it is trying to turn like your regular hand mixer does when you push down on it.
The drive sprocket has to turn just enough to propel the rear of your mixer half a turn, which in turn will spin your dough half a revolution at low speed.
Making certain that your stop switch is not engaged ensures that you can always turn on your mixer – even if you don’t happen to be pushing down on it.
If you take off your old mixing attachments and replace them with a new mixing bowl and beaters altogether, now it should work.
Faulty Clutch Band Kit
Clutch assemblies are responsible for engaging the clutch drum so that the chain can rotate. If they are worn out or not engaging properly, the motor will continue running but the assembly won’t engage and so the chain won’t rotate.
First, remove the stop lever because in some cases it must be disengaged so as to get things spinning again. If you’re experiencing issues with your clutch assembly, replace it with a new one as soon as possible to avoid further problems.
Drum Brake issue
The clutch band is a special metal band used to make the chain turn in your device if the sprockets are engaged. This function is only available when the clutch band drum brake engages the clutch drum to allow the chain to turn freely.
If the clutch band becomes worn, the motor will run but the clutch band won’t engage and therefore your part won’t move. Make sure that the stop lever is disengaged if you want it to prevent freewheel mode so that it will allow this part to spin while your part cycle smoothly.
The problem usually lies in either one’s moving parts or material that helps control how those parts work together so be prepared to either fix rusty or worn out gears or replace them with new ones.
Why is my Husqvarna chainsaw chain not turning?
Disengage the stop lever. The chain will not turn with the stop lever engaged. If the clutch pads are worn out, replace them by first opening up the clutch assembly which you do by removing a few screws meanwhile carefully watching not to lose any of these parts.
What causes a chainsaw chain to lock up?
When looking over a chain saw, make sure you check for debris or sawdust that might be stuck inside the chain. Often times some chips of wood can get stuck inside the gears and prevent them from turning freely.
To help loosen a chain hold still due to stuck wood chips use a screwdriver to scrape greased sawdust out of all the areas located around where it could have gotten trapped.
Related guides