How To Take Off Fluorescent Light Cover. Fluorescent lighting is a popular choice for any space that requires efficient and long-lasting illumination, but they need to be handled with care as there are a lot of risks involved.
To fix or remove fluorescent lighting, touch only the fixture itself to avoid electric shocks from the fixture’s power source. Disconnect it from the electrical circuit using a screwdriver and then remove the cover, bulbs, and fixture base if necessary.
Replace any of these components with those found in a standard light bulb and go about your day with proper lighting again.
How To Take Off Fluorescent Light Cover
On the sides of the lens is a lip with a ledge, making it easy to push out of place. To remove a wraparound fluorescent light cover, grab one of its long sides, push up, and then pull it down. Repeat this process for the other side.
We will discuss how to remove the fluorescent light cover here.
1. Clean the floor area beneath the bulb of the light fixture which you want to remove. Find a ladder tall enough to reach the lighting fixture, stand on it, and then remove the bulb while holding it with both your hands.
2. Hold the upper lip of an acrylic cap on one side of the accessory with your fingers. Pull out three layers of a small flathead screwdriver and insert it into the pinhole that is located in the bottom corner on the same side while holding onto the clip.
Lower that side of the lid and lift the opposite side of a flathead screwdriver. Proceed to remove a wire protection cap as previously illustrated.
3. Stepladder work needs to be done. It is advisable to place the small pot-head bolts or hex head bolts securing staples on the outer edge of the accessory body of the CAP.
4. With a screwdriver, loosen the screws on the headrest tray and remove them. If you would like to loosen or remove it, you can use a bolt with a hex head.
5. One hand should be used to hold the lid in place. You will need to disengage the clamps from the body of the accessory, so you can remove the cover. To do so, rotate the clamps so that they are disconnected from the accessory, then remove the cover.
FAQs
What is the proper way to remove a 4 pin fluorescent bulb?
Insert the remover tool so it touches the base of the bulb. Slightly open the prongs by pulling apart the arms. Then position them over the base of the bulb to hold in place.
Hold onto both prongs and then move down to remove them from the socket. You may have to wiggle back-and-forth or side-to-side if you experience any resistance when trying to remove it.
What is the best way to remove a light cover without screws?
Locate the final piece of the puzzle. Rotate it in an anticlockwise direction to loosen it. You should keep one hand on the dome at all times.
In the process of turning the final piece, the dome should start to come away from the base. If you unscrew the last piece completely, the dome should come off in your hand.
Related Guides