How to remove agitator from washing machine. An agitator is a disc fitted between two rotating drums which serve to impart motion to clothes as they are being washed.
This agitator is sometimes found in the middle of the wash drum but it is attached by a central shaft on the most common models and there are also simpler kinds where it is at the periphery of the drum.
In case this device stops working or if any part needs replacement, you must make sure that your first step should be disconnecting it from the motor.
How to remove agitator from washing machine
When you need to repair a washing machine’s agitator, there is going to be a lot that you need to know ahead of time.
The first thing that you should remember is to never attempt to remove the agitator while the drum is still in the washing machine as you might risk becoming injured.
It’s best instead to place a heavy object on top of the center of the lid so as not to damage it when operating on the agitator. Here are some tips are mentioned below:
Bolted Agitator Removing
Some washing machines may have a bolted agitator, which will typically be made of metal.
The procedure for removing this type of agitator is different from that of the more common plastic varieties seen in domestic and commercial washing machines, so please refer to your washing machine’s manual for specific instructions relating to it rather than reading here.
Now that your washing machine has been turned off, you must determine whether the agitator is removable.
As a reminder, this is a key step in the process of repairing an agitator that no longer spins because it might have broken in the first place.
If you’re lucky, as you are here, then you will be able to remove the part entirely from your washing machine using a flat head screwdriver be sure to remove all of the small connecting parts and screws before putting them aside.
Non-Bolted Agitator Removing
Some newer machines don’t come with bolts and nuts anchoring the agitator, whereas older machines do.
When you need to remove an agitator that isn’t held in place by bolting, first use a socket wrench to loosen the bolt holding down the center hub of the washing machine motor.
Unbolt the power supply of your washing machine and open the main door to gain access to the rest of the machine. You don’t even need to remove the agitator; just gently pull it off its shaft.
As long as you are not twisting or pushing too hard, it should come off without much effort – make sure not to force it.
It may be old and stiff, so if you have a lubrication spray handy, a squirt of that might help loosen it up.
If you’re struggling with getting your washer’s agitator out after following these instructions, then contact an appliance repair person. They’ll know what to do.
Stuck Agitator Removing
So far, we have discussed three agitator kinds non-bolted, bolted, and difficult. Now we are going to discuss the fourth type, the non-removable agitator.
First, you should ensure that it does not have any bolts or nuts. Sometimes the houses of whirlpools get blocked with chemicals, soaps, and detergents, causing them to become hard to remove later on.
So make sure your pool has no residue attaching it at the base before attempting removal for your sake and for its sake.
When the agitator needs to be replaced, we advise trying another load without the agitator in place before deciding to replace it. The replacement could turn out to be just as faulty.
Related Guides