How to open a lock box. A lockbox is a new way to keep your keys safe. The lockbox can open and close just like a normal box with a keyhole, but inside there’s also a high-security biometric fingerprint scanner built-in.
This means you don’t have to worry about keeping track of your key it comes with you. Also, if there’s an emergency and you don’t have access to the box.
No worries, everyone’s biometric information is saved within the device so you can call anyone tied to that number without having to look them up first.
How to open a lock box
Lockboxes can be very helpful in securing valuables as well as important papers, but what happens if you lose your keys inside the box? How do you open that lockbox without a key?
Luckily, there are a number of ways to get into that lockbox without losing your mind or damaging anything.
Picking Locks
Locking a box without a key can be rather difficult. You have to pull the small pin back at the side of the lock three times, using only one finger. Then you need to pull the bigger pin back, but only twice with 2 fingers.
After this, you will use 2 flatheads and a thin piece of metal (about 30 cm) and angle it downwards so that it goes right through the center hole in both pins.
Drilling Method
To lock pick a lockbox, spray the keyhole with lubricant so the drills you insert will not get stuck. Insert the drill bit into the keyhole and then put the lubricant on.
Drill through the keyhole until it reaches the lock’s cylinder. This method works for most lockboxes with a keyed cylinder.
You should use a Flathead Screwdriver
Opening a lockbox with a screwdriver isn’t hard if you have the right tools. The first thing that you should do is insert the tip of a flathead screwdriver into the keyhole and turn it anti-clockwise until it releases the mechanism.
If it’s stubborn, you can try using pliers to pull back on the lock. Or alternatively, use an electric drill bit to release it from its casing without damaging it or your property – this will ensure effective long-term usage.
Shimming is Applicable to Lockboxes
Shimming is a general lock-picking term that applies to wafer and tubular locks. Inserting small metal pieces in between the door and the frame is vital when applying shim to lockboxes.
Apply a Bypass Method
This method is not very sophisticated and involves inserting a specially designed tool into the keyway and turning it until the lock pops open.
Some hacksaw-like tools have a sharp tooth at one end which is used as leverage to pop some locks here and there but in general, standard tools should do just fine.
Enter the Correct Combination of Numbers
Dial four numbers on the electronic display and then unlock the security box. This may be a combination of three or four numbers.
Slide the security device on the lockbox using either an upward or downward motion.
Release the door and use your strength to push it open by pressing firmly at one end.
How to open a lock box
Related Guides