How To Measure For Drawer Pulls. It is possible to screw the cabinet drawer pulls into place on cabinets. There are threaded posts on the back of the pulls, and screws are inserted into the posts through holes on the cabinet face.
Two post holes are standard on drawer pulls, with a spacing of 2 1/2 inches between them. Because these hardware parts come in a variety of shapes and sizes, it’s crucial to measure them before purchasing replacements.
Replacing these hardware parts is one of the most cost-effective methods to improve your cabinets without having to buy new cabinets or countertops.
How To Measure For Drawer Pulls
Place the screws in both holes but do not tighten them, leaving a quarter-inch of wiggle area to calculate the center-to-center measurement. To determine this distance, place your ruler or tape measure over them.
This article explains how to measure drawer pulls.
Center to Center Measure
When the old ones can no longer perform their role, they must be replaced. Use a tape measure and work your way up. This length will influence the sort of pull you choose.
It may be utilized in a variety of ways depending on the distance between holes and whether they are predrilled or not.
If your kitchen island’s drawers have predrilled holes, for example, you’ll need to hold your tape measure or ruler at one hole’s center region and measure the distance to another hole.
If the holes aren’t predrilled, you’ll need to take a fresh measurement. A center-to-center distance is required to obtain a fresh pull. If necessary, convert millimeters to inches.
It’s usually measured from center to center. Divide the result by 25.4 to get inches. The most typical center-to-center pull is 2 1/2 inches. It’s possible that your new pulls will not fit into the old holes.
There’s no need to be concerned because wood filler may be used. This can successfully conceal the flaws in your previous work.
The drawer can then be painted or stained. Now you may drill the holes – but make sure you use the correct drill bit for the job.
Projection Measure
The distance between a cabinet/drawer and the pull/handle that goes on it is referred to as projection. When opening cabinets and drawers, here is where you’ll grip the handle/pull.
The more room your hand has to hold and expand, the larger the projection. Consider a bigger projection if you have large or arthritic hands because these handles will be easier to open and close.
Check the product page of each door pull you’re interested in to locate the right hardware projection for your kitchen cabinets.
Open each door and check how near it swings to other things or your cabinets while deciding the ideal size for your pulls. If there is a lot of space between your cabinet doors and other things, choose larger-sized pulls to fill up some of the gaps.
FAQs
Cabinet pulls of different sizes can be mixed?
When it comes to cabinets, there are no “rules.” It’s basically just a question of looking at as many various kitchens as you can and decide which one you want.
On drawers of various lengths, I utilized a range of sized pulls, including those from Restoration Hardware.
Of course, going that path can be costly, but cabinets are an investment item as well, so we need to make them look fantastic right away.
What are the best methods for measuring drawer slides?
Many hardware and construction supply companies sell drawer slides in a variety of sizes, the majority of which are 4 inches long.
However, these 4-inch slides normally require a minimum opening of 10 inches to function.
So, using the above-mentioned measurement method, make sure you receive a length that is longer than the distance between the back of your cabinet and the front face of your drawer.