Hotpoint Refrigerator Troubleshooting. When it comes to household appliances, Hotpoint Refrigerators are among the most popular products sold globally. If you own one and need help fixing it, look no further.
We’ve got a comprehensive guide to servicing Hotpoint Refrigerator models that tells you how to troubleshoot common issues as well as provides help with reading your Fridge’s error codes.
Hotpoint Refrigerator Troubleshooting
This article discusses how to troubleshoot some Hotpoint refrigerator problems.
Hotpoint Refrigerator Runs Non-Stop
Defrost timers might be needed if your refrigerator is constantly defrosting.
A new defrost timer will usually make the refrigerator run less by automatically shutting off the defroster and limiting the amount of time it runs.
If your current defrost timer isn’t advancing properly, it can cause your refrigerator to run excessively more than usual which will cost you more in utility costs than if you had just gotten a newer version.
The control board of your refrigerator could be defective if there is too much frost in your freezer. The board is supposed to activate a defrost sequence that melts away any frost on the evaporator coils every few hours.
For it to work the sequence must first go into cooling mode, then it switches over to defrost mode, and finally returns to cooling mode again.
If the control board has a failure with any of these steps its ability to run your refrigerator correctly will be impaired and it may cause excessive ice buildup inside of your appliance’s freezer.
Hotpoint Refrigerator Light Doesn’t Work
Check the light socket for power with a multimeter before determining whether it is defective.
If you don’t see any signs of power in the socket, that means there may be an issue with your fuse box, circuit breaker, or electrical wiring so best check those areas and get them resolved.
If you do see signs of power going into the light socket but your light bulb has yet to work even after changing it, then more than likely this means that your light bulb is defective replace it.
If the light assembly is defective, you might not be able to replace it at a reasonably low cost. Some manufacturers don’t sell these components separately they require that an entire light assembly be purchased instead.
If your product contains a light assembly, make sure to find out whether individual components are available when you need to replace them.
Hotpoint Refrigerator Won’t Cool
The start capacitor is an important part of a refrigerator’s operation. It provides an electrical boost of power to the compressor during start-up.
Without the start capacitor, it can cause your refrigerator not to cool properly. You should test the start capacitor with a multimeter if you’re having problems getting your fridge to stay cold or worse, it isn’t cooling at all.
If the start capacitor is defective, replace it as soon as possible to prevent your food from spoiling and becoming smelly.
The thermistor is crucial to ensuring that everything inside of your refrigerator remains cold. This device is designed to transmit the temperature through electrical pulses and then process it into data that your refrigerator’s control system can read and understand.
If something goes wrong with this main component, your system will be unable to regulate temperature properly and you won’t be able to keep your food at the proper safe temperatures.
Hotpoint Refrigerator Won’t Defrost
The defrost heater may be bad and needs replacing. If you didn’t know, a defrost heater melts the frost off of the evaporator coils to allow for effective healing to take place.
If there is no defrost heater in your cooling system, then frost will accumulate on your evaporator coils and this will cause cooling problems as well as poor circulation within your air conditioner.
To test your defrost heater, use a multimeter to check continuity. Your new one should pass with flying colors.
The defrost sensor monitors the temperature of the evaporator. Should that temperature exceed a certain threshold, the defrost sensor will activate the defrost heater to get rid of all the frost on your refrigerator’s evaporator.
However, should things go awry when it comes to this process, there are back-ups in place one, in particular, is a fuse that backs up everything and ensures.
That should an error occur while monitoring or activating parts of your fridge’s defrost system, you don’t stand the chance of fire breaking out as well as part damage not being compromised because some internal circuit managed to short itself.
Hotpoint Refrigerator Leaks Water
The water inlet valve has a lot of responsibility; its job is to supply water to both the icemaker as well as the refrigerator’s dispenser.
If your user notices that ice is not being made, then there might be a problem with your valve.
Take off the exterior cover and inspect for leaks then tighten its fitting at its connection on the shut-off valve.
The drain pan on self-defrosting refrigerators is used to collect the water that melts from the evaporator coils. In order to evaporate this water in the drain pan, there should be a condenser fan blowing warm air across the top of the drain pan.
When the water in the drain pan has been completely evaporated by being blown over by this warm air, it is drained out of your refrigerator’s drainage line.
A cracked or damaged drain pan may not properly allocate or dispose of the melted ice meltwater at all and instead of exiting through your refrigerator’s drain line, it could leak onto your floor instead!
Make sure that you check for cracks on your refrigerator’s drain pan and if you find any, replace it as soon as possible so that an expensive mess doesn’t appear before long.
Hotpoint Refrigerator Troubleshooting
Related Guides
