Hotpoint Dishwasher Not Draining. In any kitchen, dishwashers are one of the most useful appliances, but like all machines, they can malfunction. When a dishwasher stops working, one of the most common causes is that it is not draining properly.
When customers call their wholesaler to report problems with their machine, they often complain that their machine doesn’t drain water out of the bottom.
These standing pools of water – especially when accompanied by an unpleasant odor – are a sure sign that something needs to be repaired or replaced.
Hotpoint Dishwasher Not Draining
This article discusses some issues with a Hotpoint dishwasher that won’t drain.
Cause Of Drain Valve
Over time, debris can clog the drain. If you have a flow problem, clean out the valve. Ensure that the valve is free of debris so that water can flow through it.
If the drain is clear and still won’t actuate by itself like it should replace the valve. The drain can’t be repaired if there are any issues with its functionality so if you find that the drain is faulty you must replace it entirely.
Solenoid Kit For Drain
There is a solenoid valve on the dishwasher that opens the drain blockage, allowing water to flow out of the device and out of the clog.
However, if the solenoid malfunctions in your machine, then water will be unable to drain and will instead remain in your machine, causing damage over time.
Pump Issue With Drains
An impeller forces water through the dishwasher’s drain hose with the help of the drain pump. If the drain pump does not run, your dishwasher won’t drain.
You can test the drainage motor’s continuity (a nameplate will be attached to it) to determine if the drain pump is malfunctioning.
If the motor does not have continuity or is getting power but doesn’t run, chances are you’ll need to replace the pump with a new one which is not repairable–if it’s bad in this case you’ll just have to buy a new one.
Water Pump Belt Error
If your dishwasher is not draining well it might be due to the water pump belt being worn out or broken. Before attempting any repairs to the water pump belt.
Make sure you can identify it first by taking note of your appliance’s model number and locating where the water pump belt is on its interior as doing so will determine if you have a water pump belt inside your dishwasher or not.
You’ll then be able to use this knowledge to decide if it needs replacing, which entails removing the lower panel and looking for it on the bottom of the motor before taking a closer look to decide whether or not it requires replacing.
Drain Hose Malfunction
The drain hose of your dishwasher might be clogged. To unclog the drain hose, first, locate the drain hose most commonly near where it is connected to the garbage disposal and then detach both ends of the hose.
Next, hold one end of the hose under running water while gently shaking the other with a couple of fingers at its tip which generally is located near where your dishwasher drain branch tailpiece joins it.
Defective Check Valve
A dishwasher is normally connected to a house’s plumbing and water supply lines. As the level of water in one’s dishwasher decreases, the float switches off the pump.
Water cannot drain back into the pipes for hot or cold lines due to the check valve. If there are high levels of air left in the system.
It will keep this valve closed; thus, preventing proper drainage. If necessary, clean or replace the valve as needed to remove any buildup from blockage.
Faulty Check Ball
Located at the bottom of your dishwasher, the check ball is a small, plastic sphere. Your dishwasher’s drain stopper prevents water from flowing back into the dishwasher after it has been drained.
If a check ball is stuck, your drain won’t drain and the entire machine will stop working. Though this problem can be frustrating to figure out, fortunately, there are ways to get around it without replacing too many parts.
Related Guides