Homelite chainsaw won’t stay running. Homelite chainsaw won’t stay running, you might be best off investing in a new saw rather than trying to solve the problem with specific brands of fuel and purchasing ethanol-free gas that’s been safely stored.
If these solutions fail to fuel your two-stroke saw’s engine back up and get it running properly again, you should consider calling a crisis response team or maybe even just run your machine over in the event that things become too out of control.
Homelite chainsaw won’t stay running
Homelite chain saws are amazing in their own right, with the engine power that is mighty, but also very useful when you’re working on something nearby or have to travel a bit further away. Mixing up chainsaw chains and never using the correct one can cause the chain saw to go smoother than it should.
If the Homelite chain saw is staying difficult after the start here are some fixes for why it might be happening.
Defective Spark Arrestor
A spark arrestor is a small screen that aims to block sparks from the chainsaw as it runs. Over time, the screen becomes dirty and accumulates soot which may lead to problems with your chainsaw, such as it stalling or acting strangely.
If you notice that your chainsaw is having any issues, be sure to check whether or not your spark arrestor needs cleaning out which can be done easily by removing it and then giving it a good brush down with a wire brush.
Clogged Carburetor & Carburetor Repair Kit
A clogged carburetor is often caused by leaving fuel in the chainsaw for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance.
This sticky fuel can clog up the carburetor and cause the chainsaw engine to stall. If the carburetor is clogged, try cleaning it with carburetor cleaner.
If cleaning the carburetor isn’t effective, rebuild or replace the entire carburetor or seek professional assistance from an experienced mechanic for some help.
Fuel Filter issue
Looking for a way to get rid of gas in chainsaws? While using fuel like gasoline or kerosene, over time there may be a buildup of dirt and debris causing a problem with how the chainsaw works.
Gasoline or Kerosene fuel filters play a vital role in keeping contaminants out of the engine so that it stays clean and working. When you use your chainsaw after not using it for long periods of time remnants of old fuel may build up in its carburetor which can clog up the fuel filter.
This will also lead to you having to settle for sloppy cuts instead of sharp ones when sewing with your machine. You must always remember that when you are done cutting keep in mind how much gas is left in the tank. So that there is no need to drain it too early from the saw.
Faulty Air Filter
The air filter may be dirty, which is most likely the source of your chainsaw stalling. The air filter cleans and provides compressed air to the engine so that it can start and run properly.
If the inside of this filter somehow gets compromised or broken down, it will result in a buildup of unwanted dust that clogs its inner workings.
To remedy this problem, you should check to make sure the air filter hasn’t lost its efficiency by simply removing it from inside the engine. If it seems too dirty or worn out, you’ll simply want to replace it with a new one.
Related Guides