Craftsman Edger troubleshooting. When it comes to hardwood flooring, craftsman edge machines are some of the most demanding tools out there.
Although they operate at very high RPMs and have to be used with a lot of care and patience, they require a lot of maintenance on the part of the employee operating them.
Provided you take the effort to look after your edger, you can prolong its life expectancy in this very difficult industry. We face some issues with time but don’t worry. Our troubleshooting guide provides you with help to fix all kind of issues.
Craftsman Edger troubleshooting
If your Craftsman edger is experiencing any of these symptoms, we are here to help. Here we mentioned some common issues and their solutions; you will save time and be able to bring your Craftsman Edger trimmer back to peak performance.
Craftsman Edger won’t initiate
The spark plug ignites the fuel and air mixture in the engine’s cylinder to power the engine. If the spark plug is defective, if it has sustained damage or been worn down, then a misfire will occur, which means your engine won’t run as well as a result.
It is important to frequently check your spark plugs for signs of wear, damage, and/or fouling. You should inspect and replace them if there are any issues identified that could cause misfires.
The carburetor might be clogged. A clogged carburetor is often caused by leaving fuel in the edger for a long period of time. Over time, some of the ingredients in the fuel will evaporate, leaving behind a thicker, stickier substance.
This sticky fuel can clog up the carburetor and prevent the engine from starting. If the carburetor is clogged, try cleaning it with a carburetor cleaner.
If this does not work go ahead and replace it with a rebuild kit or a new custom-made one for expert results.
Craftsman Edger starts then stop
Every year, gardeners encounter problems with their edgers cutting out. One example of this problem is when the spark arrestor is leaking gas, which means your engine probably needs adjusting.
Spark arrestors tend to get clogged with carbon and stop the edger from working properly; replacing or cleaning it can restore the engine’s power even if only for a short amount of time depending on how bad its condition is.
The fuel filter might be clogged. The fuel filter can become clogged rather quickly if the edger had remained unused for a long period of time.
Over time, some of the ingredients in the fuel may evaporate, leaving behind a more viscous substance that cannot pass through small openings in the fuel filter system.
If old and unused fuel were left in the craftsman edger, drain the old fuel from the fuel tank and replace the fuel filter to ensure proper performance during its next use.
The air filter may be clogged or dirty. A clogged filter has a negative effect on the amount of fuel that gets sucked into the engine, and helps to create the ideal atmosphere for combustion.
If the air filter is clogged, performance suffers; in fact, there’s a chance your engine could stall as a result. So make sure you inspect it to figure out if it needs cleaning or replacing.
Craftsman Edger runs poorly
The carburetor might be clogged, most likely due to a fuel or chemical build-up slowly but surely clogging up the smaller components of the device.
A simple fix for this problem is to pour cleaning chemicals directly into the carburetor; you can use a spray with a straw attachment if you can’t reach it otherwise.
If cleaning doesn’t work or determine that it’s too difficult for you to access the carburetor, it’s probably better for you to just toss out your edger and get a new one instead.
The spark plug ignites the fuel and air mixture in the engine’s cylinder to power the engine. If the spark plug is defective, the engine may run roughly.
To determine if the spark plug needs replacing, remove it and inspect it – if there is damage or your can see any signs of carbon buildup, you will need to replace the plug.
Related Guides