Bradford White Water Heater Troubleshooting. If you’re having trouble repairing your Bradford White water heater, then you have come to the right place.
Here you will find the best Bradford White Water Heater Troubleshooting Guide that will explain common problems and provide tips to overcome them.
Bradford White Water Heater Troubleshooting
Listed below are some Bradford white water heater problems and how to troubleshoot them.
Bradford White Water Heater Overheating
The thermostat being described here determines the maximum water temperature.
If the thermostat is defective, hot water could be at an improper level. To find out if this is the case, assess hot water temperature from any faucet closest to you.
If it is hotter than the selected thermostat setting, this may mean that you have a defective thermostat.
Should the thermostat be defective, we recommend replacing it. We suggest a set temperature of 120 degrees or less to prevent burns.
If the heating element is shorted out, it will increase in temperature and heat continuously, causing the water to get too hot.
To determine if the heating element is shorted out, use a multimeter to test its electrical resistance.
If there is continuity between device terminals as in a closed circuit – and there is resistance, this indicates that the heating elements are shorted out. The next step would be to replace the heating elements entirely.
Bradford White Water Heater Doesn’t Light
The pilot light on a water heater needs to be strong. The pilot is what doesn’t allow the gas to ignite which means if it doesn’t light up then your water will never get warm.
Sometimes this might be caused by a build-up of carbon so sometimes there isn’t lighting due to this factor, but you can try replacing the pilot or cleaning it until it does get hot.
Also, remember about checking valves for water heaters – sometimes these things aren’t the greatest, but don’t freak out. Sometimes just resetting them will do the trick.
Some water heaters use a spark electrode to light the pilot flame. The spark electrode sends intermittent high-voltage sparks to light the pilot.
If the spark electrode won’t produce sparks, it is likely defective. If the spark electrode is defective, replace it with a new one.
Bradford White Water Heater Leaks
The drain valve is an important part of your water heater. It lets out water to clean the tank or maintain the equipment.
Flushing out mineral deposits or performing maintenance does not require much effort or skill and it’s something you can even do yourself if you want.
The temperature and pressure relief valve is designed to prevent the temperature of your water heater from climbing or falling to unsafe levels in order to protect you against the possibility of burns and other damage.
A proper functioning T&P valve releases excess water when too much heat builds up inside of the tank and prevents dangerous scalding by automatically releasing heated water if the thermostat isn’t turned down.
Thus, it’s important for safety reasons that your T&P valve not only works properly but also be replaced if it leaks as harmful amounts of hot water could cause an accident or burn.
Bradford White Water Heater Won’t Heat Up
Your dip tube that connects the tank to the bottom may have cracked or be broken if your hot water system does not produce enough heat.
The dip tube delivers cold water from above to the bottom of the tank where it’s heated by your water heater’s burner.
The Pressure Switch is a critical part of the ignition process.
As hot gases flow through the burner tube, they create a vacuum effect that pulls natural gas into the combustion chamber.
The pressure switch monitors this suction and, when it reaches a checkpoint, signals the Control Board to continue with the ignition process.
If the Pressure Switch malfunctions or fails completely, ignition will stall, and the burner will not ignite.
Bradford White Water Heater Troubleshooting
Related Guide